There is no requirement for the main (service) panel and any subpanels to be the same brand. But it is necessary that a panel be configured correctly as a service panel (neutral and ground bonded) or subpanel (neutral and ground not bonded). Also, a panel mounted outside must be rated for exterior weather exposure, and the panel should be designed for either surface or flush mounting, although some panels are rated for either.

   We often see two different brands at manufactured/mobile home installations, because the factory selects the brand for the interior subpanel and the local installer chooses the manufacturer for the outside service panel. All the panels are likely to be the same brand at a site-built home because they were installed by the same electrical contractor at the same time. Later additions, such as a subpanel for a new pool, are often different. 

Also see How can I tell a main electrical panel from a subpanel? and Can you add circuit breakers by different manufacturers to an electric panel if they fit? and What is the maximum number of circuit breakers allowed in an electric panel? 

• • • • • • • • • • • • • • • • • • • • • • • • • • 

Here’s links to some of our other blog articles about ELECTRIC PANELS:

• What causes copper wires to turn green or black in an electric panel?  

 • When should a corroded or damaged electric panel cabinet or disconnect box be replaced? 

• What is a tandem circuit breaker? 

• When did arc fault circuit interrupter (AFCI) breakers first become required?

• Can an electric panel be located in a closet? 

• Can an electric panel be located in a bathroom? 

• My circuit breaker won't reset. What's wrong?  

• What is a split bus electric panel?

• How do I identify a combination AFCI (CAFCI) circuit breaker? 

• What does a circuit breaker with a yellow or white test button indicate? 

• What is the maximum gap allowed between the front of a recessed electric panel box and the wall surface surrounding it? 

• What are the requirements for NM-cables entering an electric panel box?

• Why is a fuse box/panel an insurance problem for homebuyers? 

• Why is bundled wiring in an electric panel a defect?

• What is the difference between GFCI and AFCI circuit breakers? 

• Why are old electrical components not always "grandfathered" as acceptable by home inspectors?

• What happens when you press the "TEST" button on a circuit breaker in an electric panel?

• What is a Dual Function Circuit Interrupter (DFCI)? 

• What is the difference between a Combination Arc Fault Circuit Interrupter (CAFCI) and an Arc Fault Circuit Interrupter (AFCI) circuit breaker?  

• What is the difference between "grounded" and "grounding" electrical conductors? 

• What does it mean when a wire is "overstripped" at a circuit breaker?

• Why is an old fuse panel dangerous?  

• Who is the manufacturer of those "bad" electric panels?

• Why is the circuit breaker stuck in the middle? 

• What is a double tap at a circuit breaker?

• What is the right electric wire size for a circuit breaker in an electric panel?

• What is the life expectancy of a circuit breaker? 

• My circuit breaker won't reset. What's wrong? 

• Why do some breakers in my electric panel have a "TEST" button on them?

• What is the right size electric panel for a house? 

• What do I need to know about buying a whole house surge protector? 

• What is the maximum allowed height of a circuit breaker (OCPD) above the floor?

• What is the maximum height you can mount an electric panel above the floor? 

• What is the code required clearance in front of an electric panel?

• What is the main bonding jumper and where do it find it in an electric panel? 

   Visit our ELECTRIC PANELS page for other related blog posts on this subject, or go to the INDEX for a complete listing of all our articles.